The G-Code editor has it’s own small toolbar, where you can select the most important functions. If you want to edit the G-Code, click Edit G-Code. You will get a rendered preview image and you can start the print job from the host via the Server tab or in Repetier-Server. Save to Server: If the host is connected to Repetier-Server, you can save the G-Code in Repetier-Server.
TAZ5 REPETIER SERVER CODE
If the SD card is in the printer, you need to save the G code via the tab SD Card.
The SD card should be in the computer, which is significantly faster than when the SD card is in the printer. If your printer runs with Repetier-Firmware, you can save it in binary format. Save for SD Print: Here you save the G-Code for SD Print including additional start- and endcodes and job finishing commands, that are stored in printer settings.Safe to File: Click here to save the generated G-Code on your hard drive without additional start- and endcodes, that are stored in printer settings.If the host is connected via Repetier-Server, the G-Code is sent to the server and then the print job will start, so that you can close the host. Print: This will start the print job directly.If everything is OK, you can save the G-Code or start the print job with this commands: So you can check if everything is correct before printing, what can save a lot of time and money.
You can rotate and inspect the whole model, a layer range or just single layers and you can visualize the travel moves. After slicing you can see the slicing result.
0 kommentar(er)
